Paxton Net2 nano Manual de Instalação descarregar pdf (Página 3)

Page 3

The Net2 software should be loaded on the controlling PC and at least one Net2Air bridge congured to

communicate with the unit.

Software installation

Full documentation is supplied with the Net2Air bridge unit and also on the website as follows:

XAN1051 - Installing Net2 software < http://paxton.info/1520 >

XIns-30084 - Net2Air USB bridge < http://paxton.info/926 >

XIns-30085 - Net2Air Ethernet bridge < http://paxton.info/920 >

INPUT / OUTPUT WIRING

Lock output - This is a transistor 'open drain' output, (not a voltage free contact) that has been designed

to simplify the wiring of the lock. It can be congured to operate in Fail lock, Fail unlock or toggle modes and

removes the need for additional links or diodes normally required when using a relay for output switching.

Relay output - This provides a set of volt free contacts to switch external devices.

Alarm output - This is a transistor driven output that switches to 0V when activated.

The Net2 nano has 3 outputs that can be congured in the Doors screen to perform different functions.

This exibility means that a site that requires the Relay output (volt free contacts) for the door function can

congure the Lock output to drive a door bell.

Only ONE Net2Air USB bridge may be used per system. Multiple Net2Air Ethernet bridges may also be congured.

1 2 3 4 5

Sem comentários

Paxton Net2 nano Manual de Instalação Página 3