Paxton Net2 Ethernet Interface Manual do Utilizador descarregar pdf (Página 3)

When connecting to a LAN

The IP address should be assigned a xed value, or should be given a DHCP reservation. Unreserved IP addresses

issued by DHCP servers are not guaranteed to be constant, leading to potential failure of communication between

Net2 software and the device.

Run the Net2 Server Conguration Utility (Start/Programs/Net2) and Click on TCP/IP nodes.

Click on;Detect and the MAC address of the device(s) will appear in the table. You must then use the “IP address

conguration” tab to manually assign the IP address, subnet mask and gateway.

Be aware that if the IP address that you give the device is not in the same IP range as the PC, the device will no

longer respond until you connect to it with a PC that is in the same IP range.

Some rewall/virus protection software and other wireless hardware can block the IP detection process. Disable

these and try to detect the device again. Please contact Technical Support if you require further advice.

*The MAC address can be found on a label next to the PSU and starts 00-0B-D6-etc.

1 2 3 4

Sem comentários

Paxton Net2 Ethernet Interface Manual do Utilizador Página 3